1. 斷開電源，確保設備處于狀態。

Firstly, disconnect the power supply to ensure that the device is in a safe state.

2. 拆卸原有的油封。

2. Disassemble the original oil seal.

3. 用清潔布擦拭滾珠絲杠、螺母和軸承等零部件表面，確保表面干凈無雜質。

3. Wipe the surfaces of components such as ball screws, nuts, and bearings with a cleaning cloth to ensure that the surfaces are clean and free of impurities.

4. 拆下螺母，并將滾珠絲杠從螺母中取出。

4. Remove the nut and take out the ball screw from the nut.

5. 檢查滾珠絲杠、軸承等零部件是否有損壞或磨損，如有需要更換。

5. Check whether the ball screw, bearings and other components are damaged or worn, and replace them if necessary.

6. 安裝新的油封，注意安裝方向和密封性。

6. Install a new oil seal, paying attention to the installation direction and sealing performance.

7. 將滾珠絲杠重新安裝到螺母中，并將螺母擰緊。

7. Reinstall the ball screw into the nut and tighten the nut.

8. 測試設備運轉是否正常，如有異常情況需要進行調整或排除故障。

8. Test whether the equipment is operating normally, and adjust or troubleshoot any abnormal situations.

9. 檢查滾珠絲杠、螺母和軸承等零部件的潤滑情況，如有需要進行潤滑。

9. Check the lubrication of components such as ball screws, nuts, and bearings, and lubricate them if necessary.

10. 將設備恢復正常工作狀態。

10. Finally, restore the device to normal working condition.

以上的內容來自：導軌絲杠更多的精彩內容請點擊我們的網站：http://m.02n93m.cn

The above content comes from: Guide screw. For more exciting content, please click on our official website: http://m.02n93m.cn